-Assemble Legs –

You will cut a total of 7 pieces for the frame. Use 3 of the 8′ 1×4 and 1 6′ 1×10 boards for the frame. Use one of the 1×4 boards; cut 2 – 31 7/8″ length pieces and 1 – 30 3/8″ length piece. Next, cut 2 – 64″ length pieces, one out of each of the 2 remaining 1×4 boards. Finally, cut 2 – 30 3/8″ length pieces out of the 1×10 board.

In this part 1 of a 6 part article series, we’ll cover a few tips to lighten the load of playing host for a poker tournament.

Keep in mind, there are many different kinds of poker games you can play, and you will need to pick the right able to match this. Very simply, if you like to play a wider variety of poker games, than a standard octagon shaped table would probably be the best thing to purchase.

Step 7 – Fasten Frame to Table Top

For this we do not need to buy an expensive poker table from the market. All we need to do is to get the right tools and the accessories and assemble the table in our backyard garage. This helps us to save precious money and all we have to spend is our time and effort. The stainless steel used is chromed which will prevent the steel from any environmental damage.

2. Preparing the materials and tools

Step 15 – Fasten Rail in Place

Lay the Felt out on the table with an even amount over hanging on the sides. Use a staple gun to fasten the felt to the table. You will be stapling the felt into the edge of the table.

These are step by step instructions for building a poker table. The table will measure 48″ x 96″ and have a 4″ wide rail. This will provide adequate seating for 10 players.